Integrated Circuit Chip

Product Details:

The ISO3080 and ISO3086 devices are isolated full-duplex differential line drivers and receivers while the ISO3082 and ISO3088 devices are isolated half-duplex differential line transceivers for TIA/EIA 485/422 applications.

These devices are ideal for long transmission lines because the ground loop is broken to allow for a much larger common-mode voltage range. The symmetrical isolation barrier of the device is tested to provide 2500 VRMS of isolation for 60 s per UL 1577 between the bus-line transceiver and the logic-level interface.

Any cabled I/O can be subjected to electrical noise transients from various sources. These noise transients can cause damage to the transceiver and/or nearby sensitive circuitry if they are of sufficient magnitude and duration. These isolated devices can significantly increase protection and reduce the risk of damage to expensive control circuits.

The ISO3080, ISO3082, ISO3086, and ISO3088 device are qualified for use from –40°C to +85°C.

Product Details:

The W79E4051/2051 series are an 8-bit Turbo 51 microcontroller which has an in-system programmable Flash EPROM which Flash EPROM can program by ICP (In Circuit Program) Writer. The instruction set of the W79E4051/2051 series are fully compatible with the standard 8052. The W79E4051/2051 series contain a 4K/2K bytes of program Flash EPROM; a 256 bytes of RAM; 128 bytes data Flash EPROM for customer data storage; two 8-bit bi-directional and bit-addressable I/O ports; two 16-bit timer/counters; an enhanced full duplex serial port; 1 channel PWM by 10-bit counter, Brownout voltage detection/reset, Power on reset detection and one analog comparator. These peripherals are supported by 9 sources of four-level interrupt capability. To facilitate programming and verification, the Flash EPROM inside the W79E4051/2051 series allow the program memory to be programmed and read electronically. Once the code is confirmed, the user can protect the code for security

Product Details:

Based on Avia Semiconductor’s patented technology, HX710 is a precision 24-bit analogto-digital converter (ADC) with built-in temperature sensor designed for weigh scales and industrial control applications to interface directly with a bridge sensor. The input low-noise amplifier (PGA) has a fixed gain of 128, corresponding to a full-scale differential input voltage of ±20mV, when a 5V reference voltage is connected to the VREF pin. On chip oscillator provides the system clock without any external component. On-chip power-on-reset circuitry simplifies digital interface initialization. There is no programming needed for the internal registers. All controls to the HX710 are through the pins.

Additional Information:

• Packaging Details: 2500 PCS REEL

Product Details:

CH340 is a USB bus conversion chip, it can realize USB to UART interface or USB to printer interface. In serial UART mode, CH340 provides common MODEM liaison signal, used to expand UART interface of computer or upgrade the common serial device to USB bus directly.

Additional Information:

• Item Code: CH340C
• Packaging Details: 100 PCS TUBE

Product Details:

The LM358B and LM2904B devices are the next-generation versions of the industry-standard operational amplifiers (op amps) LM358 and LM2904, which include two high-voltage (36 V) op amps. These devices provide outstanding value for cost-sensitive applications, with features including low offset (300 µV, typical), common-mode input range to ground, and high differential input voltage capability.

The LM358B and LM2904B op amps simplify circuit design with enhanced features such as unity-gain stability, lower offset voltage maximum of 3 mV (2 mV maximum for LM358BA and LM2904BA), and lower quiescent current of 300 µA per amplifier (typical). High ESD (2 kV, HBM) and integrated EMI and RF filters enable the LM358B and LM2904B devices to be used in the most rugged, environmentally challenging applications.

The LM358B and LM2904B amplifiers are available in micro-sized packaging, such as the SOT23-8, as well as industry standard packages including SOIC, TSSOP, and VSSOP.

Additional Information:

• Item Code: LM358DR
• Packaging Details: 2500 PCS REEL

Product Details:

Shenzhen honglifa Electronics Co., Ltd. is a professional company specializing in the production of semiconductors, integrating design, streaming, testing and sales. A technical team with strong technical force, advanced technology and good cooperation with well-known film and closed testing companies at home and abroad not only ensures the stability of "HLF" brand, but also ensures that the core of enterprise competitiveness is technology, and the market is the guarantee for enterprise promotion. While producing old products, we launch newly upgraded high-quality products, which can replace many imported IC models, in order to achieve the enterprise concept of sustainable development, and integrate relevant upstream and downstream resources based on the advantages of vertical division of labor in China's semiconductor industry.

Product Details:

The TL08xH (TL081H, TL082H, and TL084H) family of devices are the next-generation versions of the industry-standard TL08x (TL081, TL082, and TL084) devices. These devices provide outstanding value for cost-sensitive applications, with features including low offset (1 mV, typical), high slew rate (20 V/µs), and common-mode input to the positive supply. High ESD (1.5 kV, HBM), integrated EMI and RF filters, and operation across the full –40°C to 125°C enable the TL08xH devices to be used in the most rugged and demanding applications.

Product Details:

The MC74HC165A is identical in pinout to the LS165. The device inputs are compatible with standard CMOS outputs; with pullup resistors, they are compatible with LSTTL outputs. This device is an 8−bit shift register with complementary outputs from the last stage. Data may be loaded into the register either in parallel or in serial form. When the Serial Shift/Parallel Load input is low, the data is loaded asynchronously in parallel. When the Serial Shift/Parallel Load input is high, the data is loaded serially on the rising edge of either Clock or Clock Inhibit (see the Function Table). The 2−input NOR clock may be used either by combining two independent clock sources or by designating one of the clock inputs to act as a clock inhibit

Product Details:

The M24C32 is a 32-Kbit I2C-compatible EEPROM (Electrically Erasable PROgrammable Memory) organized as 4 K × 8 bits. The M24C32-W can operate with a supply voltage from 2.5 V to 5.5 V, the M24C32-R can operate with a supply voltage from 1.8 V to 5.5 V, and the M24C32-F and M24C32-DF can operate with a supply voltage from 1.7 V to 5.5 V, over an ambient temperature range of -40 °C / +85 °C; while the M24C32-X can operate with a supply voltage from 1.6 V to 5.5 V over an ambient temperature range of -20 °C / +85 °C. The M24C32-D offers an additional page, named the Identification Page (32 byte). The Identification Page can be used to store sensitive application parameters which can be (later) permanently locked in Read-only mode.

Product Details:

HX710B 24 Bit Analog to Digital Converter With Built-in Temperature Sensor – SOP-8 package

Based on Avia Semiconductor’s patented technology, HX710 is a precision 24-bit analog-to-digital converter (ADC) with a built-in temperature sensor designed for weigh scales and industrial control applications to interface directly with a bridge sensor. The input low-noise amplifier (PGA) has a fixed gain of 128, corresponding to a full-scale differential input voltage of ±20mV when a 5V reference voltage is connected to the VREF pin. On-chip oscillator provides the system clock without any external components. On-chip power-on-reset circuitry simplifies digital interface initialization. There is no programming needed for the internal registers. All controls to the HX710 are through the pins.

Features:

• On-chip temperature measurement
• On-chip active low noise amplifier with a gain of 128
• On-chip oscillator requiring no external component
• On-chip power-on-reset
• Simple digital control and serial interface: pin-driven controls, no programming needed
• Selectable 10SPS or 40SPS output data rate
• Simultaneous 50 and 60Hz supply rejection

Features/Specs:

• Manufacturer: AVIA Semiconductor
• Manufacturer Part No: HX710B
• Power supply voltage: 2.6 ~ 5.5V
• Digital supply current: 100uA
• Full-scale differential input voltage range: ±3.9*VREF mV
• Common mode input range: AGND+0.9 AVDD-1.3 V
• VREF input voltage range: 1.8 AVDD
• Output data rate: 10/80 Hz
• Gain：128
• Output data coding 2’s complement: 800000 7FFFFF HEX
• Output settling time (1): 400/50 ms
• Input offset drift: 0.2 mV
• Input referred noise: 50 nV(rms)
• Input common mode rejection: 100 dB
• Power supply rejection: 100 dB
• Operation temperature range: -40 ~ +85°C
• Mounting Style: Through Hole
• Package/Case: SOP-8

Product Details:

The 74HC245; 74HCT245 is an 8-bit transceiver with 3-state outputs. The device features an output enable (OE) and send/receive (DIR) for direction control. A HIGH on OE causes the outputs to assume a high-impedance OFF-state. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.

Product Details:

The DG201B, DG202B analog switches are highly improved versions of the industry-standard DG201A, DG202. These devices are fabricated in Vishay Siliconix’ proprietary silicon gate CMOS process, resulting in lower on-resistance, lower leakage, higher speed, and lower power consumption. These quad single-pole single-throw switches are designed for a wide variety of applications in telecommunications, instrumentation, process control, computer peripherals, etc. An improved charge injection compensation design minimizes switching transients. The DG201B and DG202B can handle up to ± 22 V input signals, and have an improved continuous current rating of 30 mA. An epitaxial layer prevents latchup. All devices feature true bi-directional performance in the on condition, and will block signals to the supply voltages in the off condition. The DG201B is a normally closed switch and the DG202B is a normally open switch. (see Truth Table.)

Product Details:

The CD6283CS is a CMOS integrated circuit designed for use in a variety of applications, including automotive, industrial, and consumer electronics. It is a 12-bit, 8-channel, low-power, low-voltage analog-to-digital converter (ADC). Features: 8-channel, 12-bit resolution Low power consumption Low voltage operation High speed conversion Low noise Low distortion Low offset error High accuracy Low power shutdown On-chip reference On-chip temperature sensor Application: The CD6283CS can be used in a variety of applications, including automotive, industrial, and consumer electronics. Examples include motor control, automotive audio systems, medical equipment, and portable instrumentation. (For reference only)

Additional Information:

• Item Code: CD6283CS
• Packaging Details: 1000 PCS BOX

Product Details:

The OP07C and OP07D (OP07x) devices offer low offset and long-term stability by means of a low-noise, chopperless, bipolar‑input‑transistor amplifier circuit. For most applications, external components are not required for offset nulling and frequency compensation. The true differential input, with a wide input-voltage range and outstanding common-mode rejection, provides maximum flexibility and performance in high-noise environments and in noninverting applications. Low bias currents and extremely high input impedances are maintained over the entire temperature range.

For improved performance and wider temperature range, see the next generation OPA207 with low power, and OPA202 with heavy capacitive load drive capability.